Tools4SDR : Test the installation of the Tools4SDR toolbox

Tutorial : Using the USRP with Matlab and Windows
1. Install the USRP (Windows) 2. USRP interface with Matlab and Windows 3. Test the installation of the Tools4SDR toolbox 4. The "hello world !" of the communication with two USRPs, matlab and windows

Discussion
The last comment is from Tools4SDR: If you have issues : pierre _at _ tools4sdr.com Add a comment

Structure of this article
1 What is needed ? 2 Test script

More about GNU Radio & USRP >> USRP & Matlab
USRP interface with Matlab and Windows Estimation of the RF impairments of the USRP throught channel impulse response estimation The "hello world !" of the communication with two USRPs, matlab and windows Symbol rate estimation of linearly modulated sequence of symbols

See also
GNU Radio & USRP >> Generalities GNU Radio & USRP >> Tutorials GNU Radio & USRP >> USRP & Matlab GNU Radio & USRP >> SDR4All tools

Test the installation of the Tools4SDR toolbox

This page describes a simple test that can be performed to check that the toolbox is correctly installed.

1. What is needed ?

To run this test, you need an USRP plugged and connected to a PC running Windows, matlab, and the toolbox.

2. Test script

The commands are the following ones:

USRP_Configure

Tells to matlab the daughterboard connected to the USRP. This command has to be runned each time the daughterboard is changed.

USRP_Init

Inits the USRP.

USRP_GetSerialNumber

Returns the USRP serial number.

Screen capture of matlab

You can also try the Hello World! of the toolbox.